Help & Support

Reply
aspirant
kulsum
Posts: 3,578
Registered: ‎29-08-2010
Best Answer

microsim cutting - white edge help :/

Hi, iv been cutting microsims and 1 sim the bottom edge whit part is ther but its been dug into a bit by the cutter if u get wat i mean so shud i send that sim out o not? also anuther sim thers hardly ne white stuf on one corner of the sim..so shud i send tht one or not? thanx :smileyhappy:
For a free Normal SIM/MicroSIM/NanoSIM click below:
Get a free giffgaff Sim
jamesd2010
Posts: 7,297
Registered: ‎14-10-2010
vanguard
maheed
Posts: 4,133
Registered: ‎28-11-2010

Re: microsim cutting - white edge help :/

Yeah I think it'll work as long as the metal plate is intact
zippygeorgebungle
Posts: 6,762
Kudos: 919
Registered: ‎04-05-2011

Re: microsim cutting - white edge help :/

If any part of the metal has been messed with i would never send it out just bin it. You dont want to be known as the dodgy sim provider
Get a free giffgaff Sim

tipster
luky_1992
Posts: 462
Registered: ‎05-11-2011

Re: microsim cutting - white edge help :/

as long as the "metal' part is intact it will work however try cutting them better for your own reputation.

Get a free Giffgaff Sim
If you think I helped, click on accept as a solution or give me a kudos(yellow star).
welshdragon92
Posts: 4,320
Topics: 27
Kudos: 649
Blog Posts: 0
Ideas: 3
Best Answers: 180
Registered: ‎01-06-2011

Re: microsim cutting - white edge help :/

I don't send any sims out that I have got too close and cut through the metal. There should be a little amount of plastic around the metel part.
Microsims here http://ggs.im/m-welshdragon92
Get a free Giffgaff Sim
welshdragon92
Posts: 4,320
Topics: 27
Kudos: 649
Blog Posts: 0
Ideas: 3
Best Answers: 180
Registered: ‎01-06-2011

Re: microsim cutting - white edge help :/

Also make sure their done correctly because giffgaff do check :-)
Microsims here http://ggs.im/m-welshdragon92
Get a free Giffgaff Sim
academic
darkrage
Posts: 1,388
Registered: ‎07-07-2011
Mobile Phone: se xperia play

Re: microsim cutting - white edge help :/

Check the die in the cutter it could be worn as they are made from a soft metal. I tend to hold sim in cutter flush so it does not move when stamping out. Sims are usually ok as long as you have a 0.5 - 1mm of plastic around 2 leading edges. Hope this helped
jo2010
Posts: 2,991
Topics: 99
Kudos: 273
Best Answers: 79
Registered: ‎03-01-2011

Re: microsim cutting - white edge help :/

You should always ensure there is a section of white all around the metal part if the sim, I'd in doubt bin it.
Get a free giffgaff Sim
beginner
wingman
Posts: 37
Registered: ‎22-08-2011

Re: microsim cutting - white edge help :/

Any chance of that in english please, im 45 and aint got a clue how you younger kids text.............Lol

 

Get a free Giffgaff Sim